1976 Ford F250 Current Build

Forddaily

Well-known member
Staff member
administrator
Registered
Local time
Tomorrow, 05:23
Joined
Aug 15, 2019
Reaction score
409
Location
US
Feedback score
0
Vehicle(s)
Ford F150 Ford F250 Mustang
1976 Ford F250 Current Build.jpg


Here is my current build 1976 f250, will be installing an International DT466 with compounds, Allison MT643 Transmission married to an NP205, also building Dana 80 front & rear axles.

Says: Graham Ugalde (Owner)
1976 Ford F250 Current Build 2.jpg

1976 Ford F250 Current Build 3.jpg

Dana 60/70 narrowing jig, will need to machine larger rings to go around the carrier bearing pucks in order to accommodate the larger carrier bearing in the Dana 80.
Rockwell spindle on the left is what I’ll be running, Dana 60 front spindle on the right for comparison.
Coupler i made from the output yoke on the MT643 transmission, I machined the yokes off of it, did the same with the divorced NP205 transfer case yoke, I pressed the 205 yoke into the 643 yoke, with a .010” press, dialed it in & welded it up, this is an unfinished piece, will cut it down further, sleeve it & weld.
I also had to cut 1.750” off of the water pump shaft, also machined .625” off of the water pump pulley flange, I needed to shorten this operation up as much as possible, she is 93” from the end of the water pump to the center of the output yoke.
1976 Ford F250 Current Build 4.jpg

1976 Ford F250 Current Build 5.jpg

1976 Ford F250 Current Build 6.jpg

1976 Ford F250 Current Build 7.jpg

1976 Ford F250 Current Build 8.jpg

1976 Ford F250 Current Build 9.jpg

1976 Ford F250 Current Build 10.jpg

1976 Ford F250 Current Build 11.jpg

1976 Ford F250 Current Build 12.jpg

1976 Ford F250 Current Build 14 (1).jpg

1976 Ford F250 Current Build 14 (2).jpg

1976 Ford F250 Current Build 16 (1).jpg

1976 Ford F250 Current Build 16 (2).jpg

1976 Ford F250 Current Build 18 (1).jpg

1976 Ford F250 Current Build 18 (2).jpg

1976 Ford F250 Current Build 20 (1).jpg

1976 Ford F250 Current Build 22 (2).jpg
 
Top