The second Readers Rides post is Colton’s 1979 Ford F150 Custom out of Ontario, Canada. This build story is quite a roller coaster with the truck being finished, crashed and then rebuilt. Read the story below and check out the build pictures.
Colton and his Dad restore old Ford pick up trucks as a hobby (Nice!). He was in the market for a 1970’s Ford project truck and came across an ad for a 1979 Ford F150 Custom (the black F150 in the pictures) which looked like a good project truck. Colton and his Dad went down to look at it and as soon as they saw it they knew it was going to need some serious work. Lots of Bondo could be seen and it was badly rotted out (as we’ve all experienced, it looked better in the pictures). The truck was built in Ontario so it would have seen its fair share of salt and bad roads. But, it had a freshly rebuilt 460 and Detroit lockers, so they got the guy talked down to $700 and bought the truck for the drivetrain (wish I could find deals like that).
They started stripping the truck down and diving in to the build a couple days after they bought it. There wasn’t much left of the bed and the previous owner had tried to repair it with fiberglass patches (sounds similar to the 78 F250 build eh?). They picked the bed up and it just about folded in half. The cab was also rotted out and had its share of Bondo in it. Colton’s Dad knew a guy who had a few Dentsides laying out in a field that were basically parts trucks. They went out and grabbed one with a good cab and bed (the blue Ford with the smashed front end). The truck had been hit in the front end, wrote off and left to sit in a field. Colton and his Dad dragged it out of the field, brought it home and welded in floors and pulled some dents. Then they block sanded it all down and Colton primed it a couple of times to get it ready for paint. Colton picked out a nice dark silver color and let the paint fly.
After that they stripped and painted the frame and engine while the cab and bed were off the frame. They put the bed on about a week later when the paint was cured and started the assembly process. They put in an all new fuel tank, fuel lines, break lines, master cylinder, weather stripping and more. Then they wired it up and put the windows in and bumpers on and the truck was ready. Colton drove it for a little while on 35’s and then bought a set of 42″ Super Swamper Irok’s to get the truck up a little higher. All was good for a while while Colton was driving around in the newly restored F150.
Then a couple weeks after the build was completed, Colton pulled out onto the highway and got rear ended. The force from the crash spun the truck around and rolled it 4 times into a ditch where it ended up on the passenger side. Luckily Colton was not hurt in the crash, the truck on the other hand was worse for wear but Colton dragged it out of the ditch with a backhoe and towed it home on a flat bed.